Site Overlay


To avoid injury, be careful of: Per disfarsi delle pile usate, seguire le istruzioni del produttore. NVRAM is being checked to see if it is valid. Memory map, DMA channels, and interrupts. Bateri sepatutnya dikitar semula jika boleh. Corresponds to tRAS, min.

Uploader: Dilkis
Date Added: 1 May 2010
File Size: 18.89 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 32207
Price: Free* [*Free Regsitration Required]

Controls how much system RAM is reserved for use by the internal graphics device. Turn off all peripheral devices connected to the computer. Disconnect the computer from its power source and from any telecommunications links, networks, or modems before performing any of the procedures described in this chapter.

IntelĀ® Desktop Board D865GVHZ

Setup displays the Maintenance menu. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

User allows capabilities to be changed. This setting blard appropriate when using a Plug and Play operating system.

Discard Changes Discards changes without exiting Setup. When the computer is plugged in, the standby current from the power supply extends the life of the battery.

Intel i865GV Socket 478 DDR 400/333 w/ Audio, Video and Lan m-ATX Motherboard D865GVHZL

A Error Messages and Indicators: The processor connects to the Intel desktop board through the mPGApin socket. Refer to your chassis manual for instructions on installing and removing the desktop board.


Setting items on this screen to incorrect values may cause your system to malfunction! Configures the parallel port. After saving the BIOS settings and turning the system off, unplug the power cord from the system and wait for at least 30 seconds before reapplying power and turning the system back on. On Board Parity Error A parity error occurred in onboard memory. Off turns off the fans at low system temperatures.

Replace the cover, plug in the computer, turn on the computer, and allow it to boot.

Configuring Wake-On LAN for IntelĀ® Desktop Boards

Setup only displays this menu in configure mode. Table 8 shows the jumper settings for the Setup program modes. These values have either been corrupted or the battery has failed.

It’s a community-based project which helps to repair anything. Install and use the equipment according to the instruction manual. For system safety certification, the following statement or equivalent statement is required to be permanently boaard legibly marked ln the chassis near the battery. Remove the AC power cord from the computer. The operating system assigns a drive letter to each boot device in the order listed. Gently open the retaining clips at each end of the DIMM socket.


NVRAM is being checked to see if it is valid.

Removable Devices No options Specifies the boot sequence from the available removable devices. Selects the length of time inhel before accessing a new row. When signaled by a wake-up device or event, the system quickly returns to its last known awake state. Primary master, primary slave, secondary master, and secondary slave.

HDC Failure Error occurred trying to access hard disk controller. If recovery fails, return to step 1 and repeat the recovery process.

See page 39 for information about setting configure mode. Hold the DIMM by the edges, lift it away from the socket, and store it in an anti-static package. If such a station is not available, you can provide some ESD protection by wearing an antistatic wrist strap and attaching it to a metal part of the computer chassis.